From: frank on 05/27/2000
No beeps, are you sure speaker is hooked up right. REMOVE EVERYTHING except RAM, you should get beeps. Or just the video board in (memory should be in) and see if anything comes up.Go to where you bought it and see if they can help. Must configure for correct CPU, not sure what you set 12V for? may be dead CPU or board. Take it back to have it checked. Sounds like you tried.
: Here it is:
: Blank screen on a new motherboard.
: 1. Installed a 233 MMX Mhz 3.5 V
: 2. 64 Meg SDRAM, 66 HZ 3.3V
: 3. Installed Video card
: 4. Installed all jumpers to proper location
: 5. Award BIOS
: 6. No beeps on boot-up
: 7. Set at 12V on motherboard
: 8. Bus ratio set at 66 HZ
: But still blank screen, can someone help me on this, I'm been trying to figure it out all day and still nothing, made sure I went thru the instructions on the manual and still blank screen. Your help will be truly appreciated on my part!! Thanks!!
